HTRF LCL161 - Red Ligand HTRF®

Associated products

HTRF LCL161-Red Ligand can be used for affinity binding experiments in association with the HTRF cIAP1 BIR3 Binding kit to investigate cooperativity effects within PROTAC drug discovery.

Highly specific
No-wash
Validated with reference Ab

Download the protocols

HTRF LCL161-Red Ligand can be used for affinity binding experiments in association with the HTRF cIAP1 BIR3 Binding kit to investigate cooperativity effects within PROTAC drug discovery.

Size

Cat. number selected :

Quantity

Overview

The HTRF LCL161-Red Ligand is primarily intended to perform cooperativity binding studies. It enables calculation of the affinity of the LCL161 Red Ligand for cIAP1 BIR3 protein in the presence of the targeted protein of interest. The Kd of HTRF LCL161-Red Ligand for cIAP1 protein, in absence and presence of the targeted protein, enables accurate analysis of the cooperative effect assessed with the HTRF cIAP1 BIR3 binding kit.

Benefits

EQUILIBRIUM BINDING
PHARMACOLOGICAL STUDIES
COOPERATIVITY EFFECT

HTRF LCL161 ligand binding assay principle on the cIAP1 BIR3 binding domain

HTRF LCL161 - Red Ligand binding is detected in a direct binding assay format using an anti GST-Europium Cryptate antibody which binds to GST-tagged Human cIAP1 BIR3 domain. When the dyes are in close proximity, the excitation of the donor with a light source (laser or flash lamp) triggers a Fluorescence Resonance Energy Transfer (FRET) towards the acceptor, which in turn fluoresces at a specific wavelength (665 nm) (Image A). The specific binding signal is calculated by subtracting the non-specific binding signal from the total signal, enabling Kd determination for the HTRF LCL161 - Red Ligand (Image B).

Principle LCL161-Red Ligand binding assays

HTRF LCL161 - Red Ligand binding assay protocol

Saturation binding experiments of HTRF LCL161 - Red Ligand can be run in 384-well plates by dispensing 5 µL of Diluent 9 buffer (for Total binding) or cIAP1 BIR3 Binding standard (for non specific binding). Then 5 µL of PROTAC Binding Buffer 2 (for reference) or the targeted protein diluted in PROTAC Binding Buffer 2 (for cooperativity studies) are added, followed by 5 µL of GST-tagged cIAP BIR3 protein. Finally, 5 µL of a pre-mixed solution of HTRF LCL161 - Red Ligand and Anti-GST Tb cryptate antibody are added.

The HTRF Ratio is measured after 2 hours of incubation at room temperature.

HTRF LCL161 - Red Ligand binding assay protocol

HTRF LCL161 - Red Ligand Kd (reference without PROTAC protein substrate)

12 nM ± 10 (2SD)

Determination of the affinity binding (Kd) of LCL161-Red Ligand in the presence of targeted protein

In this example, the affinity binding (Kd) of the LCL161-Red Ligand to GST-cIAP1 BIR3 protein was assessed in the absence or presence of the targeted protein BRD4 (10nM or 100nM) . This result indicates that the presence of BRD4 does not change the Kd of the Red Ligand.

Consequently this example shows that a cooperativity experiment with a PROTAC molecule composed of a cIAP ligand and a BRD4 warhead can be set up. Finally, the alpha factor can be established by dividing the Ki of the PROTAC in the binary complex (cIAPBIR3 -PROTAC) by the Ki of the PROTAC in the ternary complex (cIAPBIR3 -PROTAC-BRD4).

HTRF LCL161 - Red Ligand cooperativity assay validation

Best practices for pharmacological characterization of PPI inhibitors

Easy pharmacological characterization of PPI modulators. - Technical Notes

HTRF assays handle low- to high affinity protein-protein interactions

Deciphering low- and high affinity interactions - Application Notes

HTRF addresses large protein-protein interaction complexes

Challenge large complexes with HTRF assays - Application Notes

HTRF PPI your dream assay served on a plate

Sandwiches aren't just for eating - Infographics

Virology research solutions using HTRF Protein-Protein Interaction assays

See how peer researchers challenge the viral life cycle with PPI assays - Application Notes

Nuclear receptor ligand identification with HTRF

Monitoring nuclear receptor binding with HTRF assays - Application Notes

A brief history of Protein-Protein Interactions

How well do you know PPI? - Infographics

Manual LCL161 Red Ligand / 64bdiapb3red

64bdiapb3red - Product Insert

Technical Data Sheet LCL161 Red Ligand / 64BDIAPB3RED

64BDIAPB3RED Batch 01A - Batch Information

Safety Data Sheet (DEU) LCL161 Red Ligand / 64BDIAPB3RED